Table of Contents
Advertisement
6/15/2020
Reset Button
Use the Reset button to reset the device or restore the factory default settings. Insert a paper clip or
similar tool into the Reset pinhole and press the button. To reboot the device, press the button for 5
seconds. To return the configuration to the factory default settings, press it for at least 10 seconds.
After releasing the button, the indicator light goes dark, and then glows steady amber while the
firmware loads and the system performs a self-test. After the software finishes loading and the AP has
connected to ExtremeCloud IQ, the status indicator glows steady white.
To prevent the reset button from resetting the configuration, enter this command:
no reset-button reset-config-enable
When this command is enabled, pressing the button for 5 seconds will still reboot the AP, but pressing it
for more than 10 seconds will not reset its configuration.
Security Slot
The AP410C has a security slot for locking the device.
Extreme Networks recommends a variety of Kensington
sales representative.
Hardware Specifications
The following sections list radio, device, power, and environmental specifications for the AP410C.
Radio Specifications
Radio 1: 5 GHx 2x2 band 1 and 2 + 2.4 GHz 2x2
Radio 2: 2.4 GHz 1x1 + 5 GHz 1x1 (scanner)
Radio 3: 5 GHz 4x4 full band or 5 GHz band 3 and 4
Operating Frequency:
2402 - 2483.5 MHz for the 2.4 GHz radio
5180-5905 MHz for the 5 GHz radio
Wi-Fi Channel Support
WiFi 2.4G RX requirement: -96dBm@1Mbps
WiFi 5G RX requirement: -93dBm@6M
Bluetooth BLE Beacon (BLE 5.0)
2402 - 2480 MHz
Frequency Hopping Spread-spectrum (FHSS)
802.11a
docs.aerohive.com/330000/docs/help/english/ng/Content/hardware/ap/ap410c.htm
Pin
1
2
3
4
5
AP410C Hardware User Guide
RxD (input to AP)
TxD (output to terminal)
Signal (GND)
Signal (GND)
®
locks. For more information, contact your
Definition
NC
8/18
Advertisement
Table of Contents
