Table of Contents
Advertisement
Disposing of dust for high
performance filter
In order to drop dust sticking on the filter in the capsule,
tap the capsule 4 or 5 times with your hand.
Now point suction inlet downwards, turn capsule in
direction of arrow in diagram, and disconnect capsule
slowly and straight.
1
► 1 . Capsule 2. Suction inlet
NOTE: Dust may spill out when capsule is opened, so
be sure to set a garbage bag beneath capsule.
Remove accumulated dust from inside of capsule and
off of high performance filter.
► 1 . Capsule 2. High performance filter
Twist high performance filter in direction of arrow to unfas-
ten securing lip from cleaner unit and then pull off the filter.
► 1 . Securing lip
Clean out the fine dust and lightly tap to dislodge dust
from high performance filter.
2
1
2
1
Reassembly
Reassembly for normal filter
Put on the filter fully in position on the cleaner unit.
► 1 . Filter
NOTICE:
Make sure the filter is put on straight
without being peeled back. If the filter is put on
incorrectly as illustrated, dust will get into the motor
housing, and cause a motor failure.
► 1 . Filter
Install the prefilter. At this time, make sure to twist the
prefilter so that the securing lip is firmly locked in the
cleaner unit.
► 1 . Prefilter 2. Securing lip
7 ENGLISH
1
1
1
2
Advertisement
Table of Contents
