Installation; Cleaning, Care And Maintenance; Operation - Polar Electro U Series Instruction Manual

EN

Installation

Note: If the unit has not been stored or
moved in an upright position, let it stand
upright for approximately 12 hours before
operation. If in doubt allow to stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 5cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance for the
first time, clean the shelves and interior
with soapy water.
3. Set the brakes on the castors to keep the
appliance in position.

Operation

Control Panel
A - Power Switch
B - Light Switch
Turn On
1. Close the door(s) of the appliance.
2. Switch on the Power Switch [I]. The current
temperature within the appliance is displayed.
3. Turn the light switch On [I] or Off [O] as
desired.
Set the Operating Temperature
1. Hold the SET button for 3 seconds. The value
of the current set point will be displayed.
2. Press the or
required temperature.
3. Press the SET button to store the temperature.
4
UA023-UA024_ML_A5_v1_20220211.indb 4 UA023-UA024_ML_A5_v1_20220211.indb 4
Manual Defrost
Press and hold the defrost button "aux" for
2 seconds to begin a manual defrost. The defrost
light illuminates.
Cleaning, Care &
Maintenance
•
•
•
•
•
•
•
Condensation will form in refrigeration with
frequent opening of the doors and on hot
humid days, please ensure condensation is
allowed to drain properly or is wiped dry.
Condenser Cleaning
•
•
•
A B
•
buttons to display the
Switch off and disconnect from the power
supply before cleaning.
Clean the interior of the appliance as often as
possible.
Do not use abrasive cleaning agents. These
can leave harmful residues.
Clean the door seal with warm soapy water.
Always wipe dry after cleaning.
Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
Take care when cleaning the rear of the
appliance. Sharp edges can cut.
The condenser is part of the refrigeration
system. The condenser requires monthly
cleaning.
Always disconnect power supply before
carrying out Routine Maintenance.
Failure to clean the condenser will reduce the
performance and life of your Polar unit and
may invalidate your warranty.
These models have a removable filter which
can be cleaned with a vacuum cleaner.
2022/2/11 09:55 2022/2/11 09:55