Related Manuals for WALDIS SMARTCAM
Summary of Contents for WALDIS SMARTCAM
- Page 1 OPERATING INSTRUCTIONS SMARTCAM DOOR LOCK Electronic door lock for safe interiors, bases and compartment blocks...
- Page 2 Many thanks! ❤️ Many thanks for choosing Waldis to give you the security you want. The safe you have decided to purchase is a product tested in compliance with the EN1143-1 standard. A Swiss quality product with security tested by the VdS (German Association of Indemnity Insurers).
-
Page 3: Table Of Contents
Table of contents Overview ..........................1 Operating controls ....................... 1 Starting to use your safe interior ..................2 Operation ..........................3 Opening the safe interior .................... 3 3.2. Locking the safe interior ..................... 3 Reprogramming codes ....................4 Replacing the battery ....................5 Malfunctions......................... -
Page 4: Overview
Overview The SmartCam is mounted on safe interiors, bases and compartment blocks that are installed as options in or under the WA safe. The SmartCam is a non-certified lock. Operating controls Rotary opening Input unit with red Battery cover handle... -
Page 5: Starting To Use Your Safe Interior
Starting to use your safe interior As soon as the safe interior, base or compartment block has been delivered and correctly installed, you can start operating the lock. To do so, please keep to the following procedure: 1. Using the lug positioned on the left of the battery cover, carefully push the battery cover to the right, out of the input unit housing. -
Page 6: Operation
Operation Opening the safe interior To open the safe interior, please keep to the following procedure: 1. Enter the user code and within 3 seconds after you hear the triple acoustic signal and see the green LED light up, turn the rotary opening handle clockwise by 90°... -
Page 7: Reprogramming Codes
Reprogramming codes NOTE: A new code must always be programmed with the door open, and it must be tested! It is a mandatory requirement to reprogramme the master code (1 2 3 4 5 6) and the user code (1 1 1 1), because they could be known to a third party! What the acoustic and LED signals mean 1x signal with red LED: Input accepted... -
Page 8: Replacing The Battery
8. The green LED goes out to show that the new user code has been programmed. 9. With the door open, press any numeric key and turn the rotary opening handle counterclockwise into the "closed" position (lock closes automatically). 10. Enter the new user code and within 3 seconds after you hear the triple acoustic signal and see the green LED light up, turn the rotary opening handle clockwise. -
Page 9: Malfunctions
Malfunctions Battery If there is insufficient battery voltage, a warning signal will sound several times in succession after you enter the code, and the red LED will also flash intermittently. If you observe the warnings just mentioned, the 9 V block battery for the lock must be replaced as quickly as possible (section 3.4.).