Page 1
OPERATING INSTRUCTIONS KEYPAD LOCK CAWI SMARTCAM Electronic door lock for WA safes Issue 08.2020...
Page 2
Thank you very much ❤ We would like to thank you for choosing Waldis when it comes to safety. When buying a safe, you have chosen a product tested according to EN1143-1. A Swiss quality product with VdS - tested security.
Page 3
Table of contents is Safe lock ........................ 1 1.1. General notes ....................1 1.1.1. Notes ......................1 Code Programming ....................2 1.2. Variants ......................2 1.2.1. Opening with the user code ..............2 1.2.2. Closure of the castle ................. 2 1.2.3.
Safe lock 1.1. General notes 1.1.1. Notes • On delivery, the lock is set to the following factory codes: User factory code: 1-1-1-1 Master factory code: 1-2-3-4-5-6 For your safety, you should change these factory codes immediately. Make all code changes only when the safe is open •...
Code Programming 1.2. Variants Attention:It is essential to reprogram the original opening code (master code 1) 0 0 1 2 3 4 5 6, as a third party could know this factory code and the safe could be opened. All code reprogramming must be performed with the door open. 1.2.1.
Page 6
1.2.3. User code programming Press and hold the "0" key for approx. 3 seconds. When the key is released, the green LED lights up continuously. by the master Enter the following digit for the type of change. by the user Enter your 6-digit master code or 1 2 3 4 5 6 or enter the existing 4-digit user code e.g.,...
Page 7
1.2.5. Changing the master code Changing the master code is only possible when the lock is open. Press and hold the "2" key for approx. 3 seconds. When the key is released, the green LED lights up permanently. 2. Enter your old 6-digit master code e.g., 1 2 3 4 5 6 3.
Power supply 1.3. Things to know about the power supply The lock is powered by a 9 V alkaline block battery (no rechargeable batteries!). If the battery charge is insufficient, a warning tone will sound several times in succession after the code is entered and the red LED will flash several times.