Technical Specifications - Pureit Advanced Plus RO+MF+MP Instruction Manual

TECHNICAL SPECIFICATIONS

PUREIT ADVANCED PLUS RO+MF+MP
Model
Dimensions (HXWXD)
Weight (Complete Unit)
Flow Rate
Storage Tank Capacity
6 Stage Purifying Technology
Membrane Type
Pump Type
% Recovery 2
3
TDS Reduction
Input Water
Power Rating
Pressure Rating
Input Voltage
Material of construction
for plastic parts
Length of Power Cord
Total Dissolved Solids in
input water
Total Hardness
Iron in Input Water
Turbidity in Input Water
Pureit Advanced Plus RO+MF+MP
380mm x 166mm x 423mm
6.8 Kg
Upto 10-12 LPH
1
5 Litres
Pre-Sediment Filter, Pre-RO Carbon Filter,
Mini Filter, Reverse Osmosis Membrane,
Micro Filtration Membrane and Post-RO
Carbon Filter
Thin film composite spiral wound
Diaphragm pump, 24V DC
Typically 25%
90% (min.)
PH range 6.5-8.5,
Temperature range 10°C- 40°C
36 Watts
10-30 PSI 4
100-300 V a.c., 50 Hz
Food safe, non-toxic plastics
1.5 metres
Up to 2000 mg/lit 5
500 mg/lit (max.)
0.3 mg/lit (max.)
1 NTU (max.)
TM
Germkill Kit (GKK)
Material of Construction
GKK
Germkill performance standard
Ordering GKK
There is 1 Sediment Filter (SF) and 1 Germ Kill Kit (GKK) in the device that need to
be replaced periodically.
SF
GKK
Please call 1860-210-1000 for ordering your HUL Pureit GKK to
ensure safe drinking water, always!
1 4.8 ~ 5.2 under running water conditions.
2 Permeate flow rate and recovery are based on standard test conditions and may vary depending on input water quality,
TDS, pressure and life of Filter elements.
3
Input water quality and TDS content are important determinants of output water quality.
4 If input pressure exceeds 30 PSI, please install a company provided pressure reducing valve at an additional cost.
If the pressure is less than 10 PSI then you need to buy 'Pressure enhancing pump' at an additional cost.
Device should not be installed in a house where input pressure is greater than 60 PSI.
Post-RO Carbon Filter fitted in the device may need to be changed intermittently at extra cost in case you face smell issues.
Technical specifications are subject to change or improvement without prior notice.
5 In case the TDS is >1000 PPM, a company provided anti-scalant is recommended to be installed
This has to be purchased at extra cost.
6
This is based on standard consumption of 10 litres per day, with an input TDS of 750 PPM, 25° water and 18 PSI
pressure. Depending on the variation from above you may need to change the GKK / parts even before the stipulated time.
Food safe, non-toxic plastics
Pre-Sediment Filter - 1 No.
Pre-RO Carbon Filter - 1 No.
Post-RO Carbon Filter - 1 No.
Mini Filter - 1 No.
RO Membrane - 1 No.
Micro Filtration (MF) Membrane - 1 No.
Meets stringent international criteria for
microbiologically safe drinking water
- e.g. Environmental Protection Agency (EPA),
USA
May require cleaning/replacement basis the
water quality
Needs to be replaced approximately every
6
1 year from the date of installation
5