Installing Dimms - HP Compaq dx7300 MT Hardware Reference Manual

should be populated with the two 512MB DIMMs. With this configuration, 2 GB will run as dual
channel and 256 MB will run as single channel.
●
In any mode, the maximum operational speed is determined by the slowest DIMM in the system.

Installing DIMMs

CAUTION
Regardless of the power-on state, voltage is always supplied to the memory modules as long as
the computer is plugged into an active AC outlet. Adding or removing memory modules while
voltage is present may cause irreparable damage to the memory modules or system board.
After removing the access panel, look for the LED on the system board to the right of the DIMM
sockets. If the LED is illuminated, the system still has power. Turn off the computer and remove
the power cord before proceeding.
The memory module sockets have gold-plated metal contacts. When upgrading the memory, it
is important to use memory modules with gold-plated metal contacts to prevent corrosion and/or
oxidation resulting from having incompatible metals in contact with each other.
Static electricity can damage the electronic components of the computer or optional cards. Before
beginning these procedures, ensure that you are discharged of static electricity by briefly touching
a grounded metal object. For more information, refer to Appendix D,
When handling a memory module, be careful not to touch any of the contacts. Doing so may
damage the module.
1. Remove/disengage any security devices that prohibit opening the computer.
2. Remove all removable media, such as diskettes or compact discs, from the computer.
3. Turn off the computer properly through the operating system, then turn off any external devices.
4. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION
board as long as the system is plugged into an active AC outlet. You must disconnect the
power cord to avoid damage to the internal components of the computer.
5. Remove the computer access panel.
CAUTION
right of the DIMM sockets. If the LED is illuminated, the system still has power. Turn off the
computer and remove the power cord before proceeding.
6. Locate the memory module sockets on the system board.
WARNING!
components to cool before touching.
18 Chapter 2 Hardware Upgrades
You must disconnect the power cord before adding or removing memory modules.
Regardless of the power-on state, voltage is always present on the system
After removing the access panel, look for the LED on the system board to the
To reduce risk of personal injury from hot surfaces, allow the internal system
Electrostatic Discharge.
ENWW