Maintenance - One Stop Gardens 93358 Owner's Manual & Safety Instructions

Transparent Panel Installation Instructions
1. Panel fixtures (51) are used to secure the Transparent
Panels in place on the Greenhouse. Their
locations are marked with X on the facing page.
Note: Remove the protective film from both sides
of all panels as they are installed.
Stick the warning label to one of the Door Panels (78
)after removing the protective film from the Panel.
Install this Door Panel so that the warning label
is easily readable from outside the greenhouse.
Refer to label location on facing page.
2. The Roof Panels (74) and the Roof Window
Panel (73) will need to be placed as shown in the
insets on the facing page. The top edges of these
panels need to be placed up under the edge of the
Crown (10, 11) or the Window Support Beam (41).
3. The Panel Connectors (42) are used to connect
the Rear Top and Center Panels (70，71) to the
top of the Wall Panels (72) in the rear of the
Greenhouse. Refer to the locations marked
with O and the inset on the facing page.
Use and Maintenance
1. BEFORE EACH USE, inspect the general condition
of the Greenhouse. Check for loose screws,
misalignment or binding of moving parts, cracked
or broken parts, and any other condition that
may affect the safe operation of the Greenhouse.
If a problem occurs with the Greenhouse, have it
corrected before further use.
Do not use damaged equipment.
93358
Be careful, Panel Clip ends may be sharp and may spring back!
For technical questions,contact us.
4. One at a time, place each Transparent Panel
(70– 7 8 ) in its proper location on the Ceiling and
Frame of the Greenhouse. Then, secure the
Transparent Panel in place, using the quantity and
location of Panel Clips as shown on facing page.
5. To attach Panel Clips,
see illustration andinstructions below.
Use the included Phillips screwdriver(55)
to facilitate Panel Clip installation.
a.Place the two loose ends of the Clip into the
groove in the frame.
b.Swing the center portion of the Clip up against
the Panel.
c.Two edges of the Clip swing under the edge of
the panel and the center edge holds the panel in
place.Secure with normal bolt（52） and nut（54）
Break the self-tapping screw （59）into the middle
6.
position to secure the panel again
2. TO CLEAN: Wipe with a damp cloth, using a mild
detergent.
Do not use cleaners that are combustible,
corrosive, or not compatible with aluminum.
3. WHEN STORING: Keep the Greenhouse
in a box and in a clean, dry location.
51
Page 31