One Stop Gardens 93358 Owner's Manual & Safety Instructions page 29

Door Assembly and Installation Instructions
Parts in this phase are fastened using
8 Normal Bolts (52), 8 Nuts (54),
and 40 Door Screws (56).
Note: The Door Screws (56) thread directly into the
round portions in the center of the door frames. Leave all
Screws slightly loose until the door is mounted on the rail.
1. Place the Side Door Frame (33)
with the rubber flap down.
Attach three Center Door
Frames (36) to the Side Door
Frame (33). Assemble them
with the rounded portion facing
the front (away from the flap),
as shown to the right.
2. Using two Normal Bolts (52) and
two Nuts (54), attach the Door Slider
(34) to the Top Door Frame (35)
oriented as shown to the right.
3. Attach the Top Door Frame (35) to the Side
Door Frames (33) with the Door Slider (34) at
top and the rounded portion facing the front.
56
(view from behind)
4. Insert a Door Bottom Slider (50) into each end of
the Bottom Door Frame (37). Make sure that the
Sliders are assembled the correct way, with the gap
facing the back of the door – see diagram. Attach
the Bottom Door Frame to the Side Door Frames (33)
using two Screws (56) on each side – the one on the
top into the Bottom Door Frame and the bottom one
into the Door Bottom Slider.
5. Remove the protective film from both sides of four
Door Panels (78). Slide the Door Panels into the
door between the Door Frame (35-37) pieces.
6. Attach the other Side Door Frame (33) to the
Center Door Frames (36) in the same way.
93358
34
35
50
For technical questions, contact us.
1a
(side view)
7. Raise the assembled Door up and insert the
first roller of its Door Slider (34) onto the Door
Rail (26, 27). Carefully align the first Bottom
Door Slider (50) over the edge of the Front Floor
Plate (1a, 2a) – see illustration above. Carefully
slide the door over and align the other top Roller
and bottom Slider as you did the first ones.
8. Assemble and install the second door
by following the previous steps.
9. Once both doors are installed,
tighten all Door Screws (56).
10. Install a Normal Bolt (52) and Nut (54) into the
hole on the end of each Door Rail (26, 27),and in
the hole on the end of each Front Floor
Plate (1a, 2a) to prevent the doors from sliding
off the rails. Attach the Left and Right Rail End
Caps (60、61) onto the ends of the Door Rails.
26,27
３４／３５
(Move the door top side view)
33
50
６０／６１
３３
Page 29