Download Print this page

Belnick RATTAN TW-VN017-TAN-BK-GG Assembly Instructions

Chair with cushions

Advertisement

Quick Links

ASSEMBLY INSTRUCTIONS
Before You Begin:
Please indentify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components
may result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware (where
included) to help prevent the unit from tipping and causing accidental injury, instability, death or damage. The tipping
restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall Straps
suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Customer Service Ema il:
CustomerExperience@belnick.com
TW-VN017-TAN-BK-GG / TW-VN017-TAN-GG
Thank you for your purchase!
RATTAN CHAIR
WITH CUSHIONS
I Phone: 866-552-2810

Advertisement

loading
Need help?

Need help?

Do you have a question about the RATTAN TW-VN017-TAN-BK-GG and is the answer not in the manual?

Questions and answers

Summary of Contents for Belnick RATTAN TW-VN017-TAN-BK-GG

  • Page 1 To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed. Customer Service Ema il: CustomerExperience@belnick.com I Phone: 866-552-2810 TW-VN017-TAN-BK-GG / TW-VN017-TAN-GG...
  • Page 3 CHAIR PART LIST: SEAT LEGS CUSHION PILLOW...
  • Page 4 Turn Seat (Part A) upside down and attach Legs (Part B) using (4) M6*15 Bolts and (4) M6 Iron Washers (Part 2). Tighten using Allen Wrench (Part 1). Allen Wrench Legs Seat Place Cushion (Part C) and Pillow (Part D) onto Chair.

This manual is also suitable for:

Rattan tw-vn017-tan-gg