HP Compaq dc7600 MT Hardware Reference Manual page 45

✎
Hardware Reference Guide
5. Connect the power cable 1 and data cable 2 to the hard drive.
Connecting the Power Cable and Data Cable to a SATA Hard Drive
6. Connect the opposite end of the data cable to the appropriate
system board connector.
If your system has only one SATA hard drive, you must connect the
hard drive to the connector labeled P60 SATA 0 first to avoid any hard
drive performance problems. If you are adding a second hard drive,
connect the data cable to the system board connector labeled P61
SATA 1.
7. Replace the computer access panel.
8. If you normally lock the Smart Cover Lock, use Computer Setup
to relock the lock and enable the Smart Cover Sensor.
9. Reconfigure the computer, if necessary. Refer to the Computer
Setup (F10) Utility Guide on the Documentation and Diagnostics
CD for instructions about using Computer Setup.
www.hp.com
Hardware Upgrades
2–29