Subscribe to Our Youtube Channel
Related Manuals for TeleCare24 Fall Alarm Plan
Summary of Contents for TeleCare24 Fall Alarm Plan
- Page 1 Fall Alarm Plan - User Guide Please read and keep these instructions for future use support@telecare24.co.uk 0800 180 85 40...
- Page 2 Important information The user’s telephone MUST BE connected to the Novo telephone socket - a double adapter on the incoming line must not be used. If the user has a DECT telephone the base station MUST BE at least 2 metres away from the Novo. Failure to provide this separation may result in reduced range of personal pendants or other radio devices.
- Page 3 What’s in the box? In the box you’ll find; a Novo base unit, a fall sensor, power lead, a telephone lead and an adaptor cable. Novo Base Unit Vibby Fall Sensor Adaptor cable Telecom lead Power supply...
- Page 4 The Vibby fall sensor As the Vibby fall sensor is a life saving device; remember to wear it at all times. Please test your system via pressing your pendant every 4-6 weeks to ensure that all equipment is working correctly. Wearing your Vibby fall sensor You can wear your Vibby fall sensor either on the wrist or around the neck depending on your preference during...
-
Page 5: The Base Unit
The base unit The Novo will usually be table mounted within 3 metres of a mains supply and the master telephone socket. If extension cables are used care should be taken to ensure that no one trips over the leads. Connections Top view 1) Speakers... -
Page 6: Getting Started
Setup / placing a test call Getting started Unplug the telephone from the wall socket and plug into Novo telephone adaptor cable. Connect the Novo telephone cable into the telephone socket on the wall (where the telephone was originally plugged in). Connect the power lead between the base unit supply socket and the mains electricity. - Page 7 Existing telecom equipment If broadband is present an ADSL filter should be provided by your choosen provider. Master telephone socket Adaptor cable ADSL filter (required if broadband is present) Telephone Line If you have any connection issues or noise on the base unit audio, then a poor quality filter may be the cause.
-
Page 8: Switching Off
Switching the base unit on / off Switching on Switch the mains power supply on. Power on the base unit by pressing the grey power button on the back of the unit for roughly 3 seconds. You will see the lights on the unit run through a cycle and then your alarm will be ready to use.
Need help?
Do you have a question about the Fall Alarm Plan and is the answer not in the manual?
Questions and answers