LG L15V26 Training Manual page 86

Lcd directview television
Table of Contents

Advertisement

TV GUIDE
If the customer has a unit with TVGOS and requires a cable box due to PPV (Pay Per View) or VOD
(Video On Demand) and they desire to use TVGOS they will have to split the cable from the wall. One
leg of the splitter will have to go to the cablebox and the other will have to go to the TV. Auto
programming or EZ Scan will have to be run to load PBS and ABC channels into the unit. Any other
connection can be used from the cablebox to the TV. If the TV cannot see ABC and PBS broadcasts
with it's own tuners, TVGOS will not be downloaded to the unit. The cable box, if connected via coax
cable, will only allow the TV to be tuned to channel 3 or 4.
NOTE: If the unit has been setup as if it has a cable box in TV Guide, the channel map and G-Link are
also setup in TV Guide. The channel map will only see channels 3 or 4 and these are the only
channels the unit will tune. If the cable box is removed, setup in TV Guide will have to be
reconfigured without a cable box. This will allow the unit to tune channels other than just 3 or
4. Also, the channel map in the unit will show all channels it is authorized to see.
SYSTEM INFO
A
A
To access this menu from the TVGuide screen highlight SETUP at the top of the TVGOS screen press
the down key once to highlight CHANGE SYSTEM SETTINGS and press 753159852. The screen above
will appear. In Box (A) you can see the original version of Gemstar software the unit had when it was
built. Box (B) you can see the version the unit has been updated to. To the right of box B, this will
display the version when the unit receives an update again from Gemstar. Box (C) is the coding
Gemstar uses for the programming area the unit has been programed for. Not all zip codes have the
same or different cable provider and OTA (Over The Air) programming. As a result several zip codes
can have the same code and programming. Box (D) tells what input the TV was programmed to look
for the TVGOS signals and that the customer set it up as cable signal as the type of signal being
supplied to the TV. If the only signal supplied is OTA, this would say ANTENNA. Box (E) saying
Plasma Training
C
C
B
B
D
D
E
E
86
TV Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mu-50pz90vMu-60py2dr50pa1dr-ua

Table of Contents