Download Print this page

Bunn ThermoFresh Use & Care Instructions

Server with mechanical sight gauge
Hide thumbs Also See for ThermoFresh:

Advertisement

Quick Links

BEVERAGE DISPENSING
STEP 1
The Server Cover needs to
be removed to fill the Server
when brewing from a Bunn-
O-Matic
Dual TF DBC or
®
Single TF DBC or ICB coffee
brewer.
DAILY CLEANING
STEP 1
Run a complete brew cycle of
just hot water into the server
and let it set for a minute.
Empty the server completely
by opening the faucet.
NOTE: Bunn-O-Matic recommends the 3 step method for cleaning and sanitizing the server. The 3 step method
consists of hot soapy water using an approved detergent, a fresh water rinse, and an aqueous sanitizing solution
using an approved non-chlorine sanitizer. Do not submerge server.
39483.0001B 06/11 ©2008 Bunn-O-Matic Corporation
USE & CARE INSTRUCTIONS for ThermoFresh
STEP 2
When proper precautions
are followed, 1.0 up to 1.5
gallons of coffee may be
brewed directly into the
server and then transported
to a remote serving location.
The server must be placed on
a sturdy counter or shelf.
STEP 2
Remove the lid, fill server
with cleaning solution and
thoroughly clean the inside
of server.
with MECHANICAL SIGHT GAUGE
STEP 3
Place a cup or container in
center of serving platform
as indicated.
STEP 3
Rinse server thoroughly us-
ing fresh water rinse.
SERVER
®
STEP 4
Open the faucet handle
until the desired quantity is
dispensed.
STEP 4
Fully fill server with sanitiz-
ing solution for 5 minutes
then drain through fully open
faucet.

Advertisement

loading

Summary of Contents for Bunn ThermoFresh

  • Page 1 NOTE: Bunn-O-Matic recommends the 3 step method for cleaning and sanitizing the server. The 3 step method consists of hot soapy water using an approved detergent, a fresh water rinse, and an aqueous sanitizing solution using an approved non-chlorine sanitizer.
  • Page 2 USE & CARE INSTRUCTIONS for ThermoFresh SERVER ® with MECHANICAL SIGHT GAUGE DAILY CLEANING (Continued) STEP 5 STEP 6 STEP 7 STEP 8 Remove the faucet handle/ Use enclosed cleaning brush Remove sight gauge cap and Use enclosed cleaning brush...