Table of Contents
Advertisement
R2S133-AE77-22
3.2 Nominal data
Motor
M2S052-CA
Phase
1~
Nominal voltage / VAC
115
Frequency / Hz
50
Method of obtaining
fa
data
Valid for approval/
CE
standard
-1
Speed (rpm) / min
2790
Power consumption / W
35
Current draw / A
0.48
Min. back pressure / Pa
0
Min. ambient
-25
temperature / °C
Max. ambient
40
temperature / °C
Starting current / A
0.75
ml = Max. load · me = Max. efficiency · fa = Free air
cs = Customer specification · ce = Customer equipment
Subject to change
3.3 Technical description
Weight
0.6 kg
Size
133 mm
Motor size
52
Rotor surface
Unpainted
Impeller material
PA plastic
Number of blades
7
Direction of rotation
Clockwise, viewed toward rotor
Degree of protection
IP22
Insulation class
"B"
Moisture (F) /
H0 - dry environment
Environmental (H)
protection class
Installation position
Any
Condensation
None
drainage holes
Mode
S1
Motor bearing
Ball bearing
Touch current
< 0.75 mA
according to IEC
60990 (measuring
circuit Fig. 4, TN
system)
Motor protection
Thermal overload protector (TOP)
internally connected
with cable
Variable
Protection class
Built-in component with basic insulation,
protection class results from installation
according to intended use
Conformity with
EN 60335-1; CE
standards
Approval
CSA C22.2 No. 100; UL 1004-1
Item no. 13692-5-9970 · ENU · Change 226949 · Approved 2021-04-28 · Page 6 / 12
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · info1@de.ebmpapst.com · www.ebmpapst.com
Operating instructions
1~
; Use the device in accordance with its degree of protection.
115
60
Information on surface quality
The surfaces of the products conform to the generally applicable industrial
fa
standard. The surface quality may change during the production period.
This has no effect on strength, dimensional stability and dimensional
CE
accuracy.
The color pigments in the paints used perceptibly react to UV light over
3150
the course of time. The product is to be protected against UV radiation to
34
prevent the formation of patches and fading. Changes in color are not a
0.41
reason for complaint and are not covered by the warranty. UV radiation
0
in the frequency range and the intensity of natural solar radiation has no
-25
effect on the technical properties of the products.
45
3.4 Mounting data
Any further mounting data required can be taken from the product
0.62
drawing or Section Chapter 4.1 Mechanical connection.
Strength class of
screws
For screw clearance, see Chapter 3.1 Product drawing
; Secure the screws against unintentional loosening (e.g. use self-
3.5 Transport and storage conditions
Max. permitted
ambient temp. for
motor (transport/
storage)
Min. permitted
ambient temp. for
motor (transport/
storage)
With regard to cyclic speed loads, note that the rotating parts of
the device are designed for a maximum of one million load
cycles. If you have special questions, consult ebm-papst for
support.
8.8
locking screws).
+ 80 °C
- 40 °C
Advertisement
Table of Contents
