Table of Contents
Advertisement
Adding more laundry or removing
laundry:
If the Flex start function has
Note:
already been activated but the
programme has not yet started, you will
still be able to load more laundry or
remove some from the drum.
Press ‹ (Start/Pause).
1.
Open the door.
2.
Add or remove laundry.
3.
Close the appliance door.
4.
Press ‹ (Start/Pause).
5.
Press } (Remote Start).
6.
The FlexStart function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
Intelligent program
recommendation
After you have washed your laundry in
the washing machine, the dryer will
recommend a suitable program for
drying your laundry.
The expected duration of the
recommended program is determined
based on the washing program you just
used.
To determine the best drying program
to use, your appliances must transmit
and receive information.
Therefore please note the following:
Before the data can be transmitted,
■
the washing program must run
through to the end.
The washing machine must be
■
Home Connect-capable.
The washing machine and dryer
■
must be connected to your home
network and registered in your
Home Connect app.
Switch on the appliance.
1.
Set the program to
2.
intelligentDry È.
The analysis starts and an animation
appears in the display.
To cancel the analysis, set a different
3.
program or switch the appliance off.
Once the right programme is found, the
animation stops, the LED for the
recommended programme lights up
permanently and programme
information is shown in the display.
Press ‹ (Start/Pause).
4.
If a suitable program cannot be
Note:
found, an audible signal will sound and
{ {{ will appear on the display.
Possible reasons:
No suitable drying programs could
■
be found for the selected washing
program.
The washing machine and dryer
■
must be connected to your home
network and registered in your
Home Connect app.
Check whether your appliances are
■
within range of your home network.
No data is available for the last wash
■
program used. The data is stored for
24 hours and then deleted.
The washing program was aborted.
■
The washing program must run
through to the end.
Home Connect
en
39
Advertisement
Table of Contents
