Siemens WT4HXKE9DN Installation And Operating Instructions Manual page 38

Home Connect
en
Set the programme to position 7.
1.
"Ÿ® (Energy manager) appears in
the display.
Press ‹.
2.
Your appliance now attempts to
connect to the smart energy system
(energy manager). If the appliance
has connected successfully, ™©Ÿ
appears in the display.
Activate Flexstart if you want the
3.
smart energy system (Energy
manager) to start up your appliance.
Flex start
Activate the Flex start function to allow
your smart energy system (Energy
manager) to start your appliance once
your home photovoltaic system is able
to provide sufficient energy or the
energy tariff is good.
Your smart energy system
Note:
(Energy manager) cannot start your
appliance until it is connected to the
appliance.
Activate Flex start as follows:
Select the programme you require.
1.
Use the N and M selection buttons
2.
for the "Finished in" time to set the
required time.
Press ‹ (Start/Pause).
3.
38
Press } (Remote Start).
4.
± appears in the display.
The FlexStart function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
If the time changes on the display to
„.‹œ, for example, the smart energy
system (Energy manager) has
established a time at which your
appliance can start. The programme will
end after the specified time.
Notes
If the smart energy system (energy
■
manager) does not start your
appliance, the programme will still
be started before the set time period
ends.
The programme ends when the time
period ends.
For safety reasons, } and, in turn,
■
Flex start are deactivated in the
following circumstances:
– Press ‹.
– Open the door.
– Press # to switch off the
appliance.
– Power failure.
If the Flex start function is
deactivated, the M B N (Ready in)
remains active.