Philips AVENT SCF902 User Manual page 16

Cracking/ Avoid contact antibacterial or abrasive detergents/ cleaners.
Discoloring Combinations of detergents, cleaning products, sterilization
solution, softened water, and temperature fluctuations may
cause the plastic to crack. If any crack is found, stop using the
pump immediately. Contact Philips AVENT Consumer Care
center for spare components.
Food coloring can discolor components, but this will not affect
your usage.
Keep all the components away from the source of heat or
direct sunlight as it can discolor components.
Components Contact Philips AVENT Consumer Care center for spare
broken or lost components. See back cover for contact details.
Pump not Make sure the pump is correctly assembled and press the on/
responding off button
Make sure the cables between the pump and the power
socket are correctly connected.
Pump lights are If the five lights on the motor are sequentially flashing and
showing low the pump motor automatically stop functioning, this means
voltage warning the breast pump is in low voltage protection mode. If you use
batteries to supply power, press the on/off button
off. Replace with new batteries and switch the pump on again.
When using the power adapter to supply power, make sure it
is connected properly, then switch the pump on again. If this
problem persists, contact the Consumer Care center for help.
Pump light If the five pump lights are flashing non-stop, press the on/
is flashing off button
abnormally are assembled correctly. If the assembling is correct, but
the problem persists after switching on again, contact the
Consumer Care center for help.
14 EN
to switch on.
to switch off. Check that all components
to switch