Table of Contents
Advertisement
Home Connect
en
Resetting your network
settings
You can reset all of the network
settings.
Ensure that you are in the Home
Connect menu. ~ Page 35
Set the programme to position 5.
1.
§"à (reset network settings)
appears in the display.
Press Start|Reload ‹.
2.
¢"à appears in the display.
Press Start|Reload ‹.
3.
If you want to operate your
Note:
appliance via the Home Connect app
again, you will need to reconnect it to
your home network and to the
Home Connect app.
Updating the software
You can update the Home Connect
software on your appliance. As soon as
a new software update is available, a
note appears in the display: —˜š
Install the update directly via the
message in the display or manually as
follows:
Ensure that you are in the Home
Connect menu. ~ Page 35
38
Set the programme to position 6.
1.
—˜š (update) appears in the display.
Start|Reload ‹ flashes if a software
update is available.
Press Start|Reload ‹.
2.
¢"à appears in the display.
Press Start|Reload ‹.
3.
The software update may take
Note:
several minutes. Do not switch the
appliance off while updates are being
installed.
Energy management
You can connect your appliance to your
smart energy system (Energy manager).
Once you have connected your
appliance to the smart energy system
(Energy manager) and activated the
Flex start function, you will be able to
optimise your energy consumption
because your appliance will not start up
until your home photovoltaic system can
provide sufficient energy or the energy
tariff is good.
Further information and system
requirements for using the Energy
manager can be found at: www.home-
connect.com/energymanagement
Notes
The smart energy system (Energy
■
manager) must use the EEBus
initiative communications standard.
Before you start, read the smart
■
energy system instruction manual to
find out how to connect your
appliance to the smart energy
system (Energy manager).
Advertisement
Table of Contents
