Advertisement
WARNING! Ensure you read, understand and apply safety instructions before use.
3.2.
USING THE WRENCH
3.2.1. Fit the socket to the wrench by snapping it onto the square drive (fig 1A). Note: Use only impact grade sockets.
3.2.2. Fit the battery pack to the wrench by aligning the tongue on the battery with the groove in the housing and slide into place. Ensure that the
battery pack is firmly located, you will hear a click when it has locked into position.
3.2.3. Select the required direction of rotation. To change direction, turn the two way switch (fig.1B) to the left or right. Familiarise yourself with this
operation before use. DO NOT attempt to change the direction of rotation whilst trigger (fig.1E) is depressed.
3.2.4. If light is dim you can use the built-in LED work light (fig.1C) by pressing the push switch (fig.1D).
3.2.5. When tightening, take care not to over-torque small fixings.
Note: On critical fixings always check the torque with a torque wrench according to the product or vehicle manufacturer's
guidelines.
4. MAINTENANCE
4.1.
CLEANING
Keep the outer case of the wrench clean and free from grease. DO NOT wash with water or use solvents or abrasives. Use a slightly
dampened cloth. For any other service or maintenance, contact your authorised service agent.
Recycle unwanted materials instead of disposing of them as waste.
All tools, accessories and packaging should be sorted, taken to a recycle centre and disposed of in a manner which is compatible
with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste
authority for recycling information.
Remove the battery pack from the wrench, by depressing the two side release clips (fig.1F).
Dispose of batteries according to local authority guidelines.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of
products containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance
scheme. Jack Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Environmental Protection
Battery Removal
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
01284 757500
01284 703534
CP2144MH Issue: 1 - 09/06/16
www.sealey.co.uk
sales@sealey.co.uk
Advertisement
