Kenwood DPX-7300DAB Instruction Manual page 44

Installation/Connection
4 Rub the film antenna gently onto the windscreen in the
direction of the arrow shown to allow it to stick firmly.
5 Remove the separator (tag 2) of film antenna (E)
vertically.
Separator (tag 2)
36 ENGLISH
DPX-7300DAB_E_B5A-3899-00_EN_1st Draft.indd 36 DPX-7300DAB_E_B5A-3899-00_EN_1st Draft.indd 36
6 Set the position of the protrusion of the amplifier unit
(F) with the K mark on the film antenna (E) and paste.
Do not touch the lead terminal or the pasting surface
(adhesive side) of the amplifier unit (F).
• When installing the antenna on the right side
Earth sheet
Set the position of
the protrusion with
K mark
Lead terminal of the
film antenna (E)
Lead contact of the amplifier unit
(metal part)
• When installing the antenna on the left side
Earth sheet
7 Remove the film covering the earth sheet and paste the
earth sheet on the metal part of the vehicle.
Provide sufficient leeway for the earth sheet so that it does
not interfere with the interior parts (front pillar cover). Also
take care that the interior parts do not interfere with the
amplifier unit (F).
Windscreen
Front pillar cover
8 Wire the antenna cables.
Use cable clamper (G) to secure the antenna to the pillar at
several positions.
9 Attach the front pillar cover back to its original position.
Be sure not to damage the earth sheet and amplifier unit (F)
when covering.
10 Connect the amplifier unit (F) to the DAB antenna jack
on the rear of the unit.
Note:
Make sure [DAB ANT POWER] is set to [ON] on the
[FUNCTION] menu in standby mode. (Page 5)
[ON] is selected initially.
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Earth sheet
8/12/2021 3:35:45 PM 8/12/2021 3:35:45 PM