Phoenix International VF2-350-SCW-RHD Technical Information

Mass storage subsystem

Advertisement

Quick Links

VF2-350-SCW-RHD
MASS STORAGE SUBSYSTEM
Technical Information
Copyright © Phoenix International 1999. All Rights Reserved
812 W. Southern Avenue, Orange, CA 92865

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VF2-350-SCW-RHD and is the answer not in the manual?

Questions and answers

Summary of Contents for Phoenix International VF2-350-SCW-RHD

  • Page 1 VF2-350-SCW-RHD MASS STORAGE SUBSYSTEM Technical Information Copyright © Phoenix International 1999. All Rights Reserved 812 W. Southern Avenue, Orange, CA 92865...
  • Page 2 However, no responsibility is assumed for inaccuracies. Nor does Phoenix International assume any liability arising out of the application or use of any product or circuit described herein. Phoenix International reserves the right to make changes to any product and product documentation in an effort to improve performance, reliability or design.
  • Page 3: Table Of Contents

    Drive Hardware Configuration Hard Drive Hardware Configuration Considerations for Installation VMEbus Slot Requirements VMEbus Backplane Requirements Power Supply Requirements Installing the VF2-350-SCW-RHD Drive Software Configuration Hard Drive Software Configuration Terminator Power Configuration Operation Termination Chapter 4 Hard Disk Drive Details...
  • Page 4 Obtaining an RMA Shipping the Product Providing a Product Defect Report Warranty Repairs Non-warranty Repairs Product Updates Tables Table 2-2 SCSI Pin Definition Table 2-3 P2 Connector Pin Definitions Figures Figure 1-1 VF2-350-SCW-RHD Front Panel Figure 1-2 VF2-350-SCW-RHD Jumper Configuration...
  • Page 5: Chapter 1 Manual Organization And Introduction

    Chapter 1 Manual Organization and Introduction...
  • Page 6 This page intentionally left blank.
  • Page 7: Vf2-350-Scw-Rhd Introduction

    Fast/Wide SCSI Host Adapter. Together with the processor, a complete system can be installed in only three standard VMEbus system slots. The VF2-350-SCW-RHD provides a removable 3.5 inch low profile disk in a 2 slot 6U VME mod- ule making it very convenient to have removable data storage. The drive used in the VF2-350-SCW-RHD was chosen for compatibility, ruggedness and reliability.
  • Page 8 UNIT Figure 1-1: VX2-350-SCW-RHD Front Panel VX2-350-SCW-RHD User's Manual...
  • Page 9 Figure 1-2: VX2-350-SCW-RHD Jumper Configuration Manual Organization and Introduction 1--5...
  • Page 10: Chapter 2 Features And Specifications

    Chapter 2 Features and Specifications...
  • Page 11 This page intentionally left blank.
  • Page 12: Scope

    This chapter describes the overall features and specifications of the VF2-350-SCW-RHD. Features The VF2-350-SCW-RHD incorporates one very compact removable winchester disk drive within a single module. The hard disk drive is a high-performance winchester type with embedded disk drive control electronics. This microproces- sor controlled embedded controller is on the hard disk and is compatible with ANSI X3.131-1986 SCSI commands.
  • Page 13: Vf2-350-Scw-Rhd Specifications

    VF2-350-SCW-RHD Specifications The following table provides the specifications of the complete VF2-350-SCW-RHD. Individual disk drive specifications are given in their respective chapters. General Model: VF2-350-SCW-RHD Description: Hard disk drive module compatible with SCSI commands. Interface: Fast Wide SCSI-2 Drive Type: Particular type depends on capacity ordered.
  • Page 14 P2 Connector Pin Definitions FAST/WIDE SCSI SCSI P2 Signal P2 Pin -DB 0 -DB 1 -DB 2 -DB 3 -DB 4 -DB 5 -DB 6 -DB 7 -DPAR LTERMPOWER -ATN -BSY -SACK -RST -MSG -SEL -C/D -REQ -I/O GROUND A10, A11, A12, A14, A15, A17, A32 P2NONL GROUND B2, B12, B22, B31...
  • Page 15: Chapter 3 Configuration, Installation, And Operation

    Chapter 3 Configuration, Installation, and Operation...
  • Page 16 This page intentionally left blank.
  • Page 17: Scope

    This chapter describes how to configure, install and operate the VF2-350-SCW-RHD mass storage subsystem module. Drive Hardware Configuration The drives on the VF2-350-SCW-RHD can be configured for normal operation as SCSI units 0-15 by setting the front panel switches with a small screwdriver.(See Figure 1-1) The particular configuration of the Unit ID's required depends upon the software and the application operating system.
  • Page 18: Drive Software Configuration

    LED shows a "u" to indicate that the drive is unlocked, spun down and safe to be removed. Once the VF2-350-SCW-RHD has been configured properly and the software has been set up, operation is identical to that of a standard SCSI storage subsystem. No specialized software is required.
  • Page 19: Chapter 5 Product Support, Service And Warranty

    Chapter 5 Product Support, Service and Warranty...
  • Page 20 This page intentionally left blank.
  • Page 21: Scope

    If You Have a Problem If you are having a problem with a Phoenix International product, you should call our main number, (714) 283-4800, and ask for Customer Service. Please be prepared to supply as much detail as you can concerning the nature of the problem and the conditions in which the problem appeared.
  • Page 22: Providing A Product Defect Report

    If a product is found not to be under warranty, we will notify you of the non-warranty situation and provide you with a fixed cost and a schedule for the repair. Non-warranty repairs require that a purchase order be issued to Phoenix International for the amount of the repair before repairs are undertaken.

Table of Contents