Related Manuals for Phoenix International VL2-350-SC-SSD
Summary of Contents for Phoenix International VL2-350-SC-SSD
- Page 1 VL2-350-SC-SSD MASS STORAGE SUBSYSTEM Technical Information Copyright © Phoenix International 2005. All Rights Reserved 812 W. Southern Avenue, Orange, CA 92865...
- Page 2 However, no responsibility is assumed for inaccuracies. Nor does Phoenix International assume any liability arising out of the application or use of any product or circuit described herein. Phoenix International reserves the right to make changes to any product and product documentation in an effort to improve performance, reliability or design.
-
Page 3: Table Of Contents
Hard Drive Hardware Configuration Considerations for Installation VMEbus Slot Requirements VMEbus Backplane Requirements Power Supply Requirements Termination Terminator Power Configuration Installing the VL2-350-SC-SSD Drive Software Configuration Hard Drive Software Configuration Operation Chapter 4 Solid State Disk Drive Detail Scope Introduction... - Page 4 If You Have a Problem Product Repairs Obtaining an RMA Shipping the Product Providing a Product Defect Report Warranty Repairs Non-warranty Repairs Product Updates Tables Table 2-2 Ultra 320 SCSI Pin Definition Table 2-3 P2 Pin Definition Figures Figure 1-1 VL2-350-SC-SSD Front Panel...
-
Page 5: Chapter 1 Manual Organization And Introduction
Chapter 1 Manual Organization and Introduction... - Page 6 This page intentionally left blank.
-
Page 7: Vl2-350-Sc-Ssd Introduction
SCSI Host Adapter. Together with the processor, a complete system can be installed in only three standard VMEbus sys- tem slots. The VL2-350-SC-SSD provides one or two disk drives within the same module making it very convenient to have fixed data storage. The drives used on board the VL2-350-SC-SSD were chosen for their compatibility, rugged- ness and reliability. -
Page 8: Figure 1-1 Vl2-350-Sc-Ssd Front Panel
UNIT 0 UNIT 1 ID Switch and Disk Drive Activity indicator for Second disk drive Figure 1-1: VL2-350-SC-SSD Front Panel VL2-350-SC-SSD User's Manual... -
Page 9: Chapter 2 Features And Specifications
Chapter 2 Features and Specifications... - Page 10 This page intentionally left blank.
-
Page 11: Scope
This chapter describes the overall features and specifications of the VL2-350-SC-SSD . Features The VL2-350-SC-SSD incorporates one or two very compact winchester disk drives within a single module. The hard disk drive(s) is a high-performance winchester type with embedded disk drive control electronics. This microprocessor controlled embedded controller is on the hard disk and is compatible with ANSI X3.131-1986 SCSI commands. -
Page 12: Vl2-350-Sc-Ssd Specification
VL2-350-SC-SSD Specifications The following table provides the specifications of the complete VL2-350-SC-SSD . Individual disk drive specifications are given in their respective chapters. General Model: VL2-350-SC-SSD Description: Hard disk drive module compatible with Ultra 320 SCSI commands. Interface: Ultra 320 SCSI Drive Type: Particular type depends on capacity ordered. -
Page 13: Table
P2 Connector Pin Definitions Ultra 320 SCSI P2 Signal P2 Pin P2 Pin P2 SIGNAL +DB11 -DB 11 +DB10 -DB 10 +DB9 -DB 9 +DB8 -DB 8 +I/O -I/O +REQ -REQ +C/D -C/D +SEL -SEL +MSG -MSG +RST -RST +ACK -ACK +BSY -BSY... -
Page 14: Chapter 3 Configuration, Installation, And Operation
Chapter 3 Configuration, Installation, and Operation... - Page 15 This page intentionally left blank.
-
Page 16: Scope
If you are going to have a VMEbus card located in the next adjacent slot, you should carefully check it to make sure that no leads are likely to touch the VL2-350-SC-SSD . -
Page 17: Termination
Operation Once the VL2-350-SC-SSD has been configured properly and the software has been set up, operation is identical to that of a standard SCSI storage subsystem. No specialized software is required. Configuration, Installation, and Operation... -
Page 18: Chapter 5 Product Support, Service And Warranty
Chapter 5 Product Support, Service and Warranty... - Page 19 This page intentionally left blank.
-
Page 20: Scope
If You Have a Problem If you are having a problem with a Phoenix International product, you should call our main number, (714) 283-4800, and ask for Customer Service. Please be prepared to supply as much detail as you can concerning the nature of the problem and the conditions in which the problem appeared. -
Page 21: Providing A Product Defect Report
If a product is found not to be under warranty, we will notify you of the non-warranty situation and provide you with a fixed cost and a schedule for the repair. Non-warranty repairs require that a purchase order be issued to Phoenix International for the amount of the repair before repairs are undertaken.
Need help?
Do you have a question about the VL2-350-SC-SSD and is the answer not in the manual?
Questions and answers