Hp Vectra 500 Series Desktop - Minitower Comparison - HP Vectra 510 Technical Reference Manual

HP Vectra 500 Series Desktop – Minitower Comparison
IDE Controller
Primary channel connectors
IDE Controller
Secondary channel connectors
Flexible disk controller connectors
Accessory board slots
(on backplane)
Internal device shelves
Front-access device shelves
Desktop
Two connectors for hard disk drives
One red connector recommended for
CD-ROM
Two connectors :
- One for a 3.5-inch flexible disk drive
- One for either a tape drive or a
5.25-inch disk drive
One 16-bit ISA (short 16cm /6.3-inch)
One 16-bit ISA (full-length)
One 32-bit PCI or one
16-bit ISA Combination (full-length)
One 32-bit PCI (full-length)
One for hard disk drive
One 3.5-inch
One 5.25-inch
One 5.25-inch, 1-inch high (or an
internal drive)
1 HP Vectra 500 Series
System Overview
Minitower
Two connectors for hard disk drives
Two red connectors recommended
for CD-ROM and supplementary
hard disk drive
Two connectors for 3.5-inch
flexible disk drive
One connector for 5.25-inch flexible
disk drive or a tape drive
Maximum two devices connected
simultaneously
One 16-bit ISA (short length)
Two 32-bit PCI (full-length)
One 32-bit PCI or one
16-bit ISA Combination
Two 16-bit ISA (full-length)
Two for hard disk drives
One 3.5-inch
Three 5.25-inch
3