Table of Contents
Advertisement
Usage Notes
• To prevent fire or damage of the measurement
• Eddy current loss may cause heating of the
• Dielectric heating may cause heating of cord
• Be sure to observe all operating precautions for
• This device should only be connected to the
• Before clamping the conductor being measured,
12
target and device as well as burns, exercise
caution concerning the following when measuring
high-frequency currents or currents that contain
high-frequency components:
sensor head.
insulation and other materials.
the waveform measurement instrument and other
measurement instruments to which this device is
connected.
secondary side of a breaker, so the breaker can
prevent an accident if a short circuit occurs.
Connections should never be made to the
primary side of a breaker, because unrestricted
current flow could cause a serious accident if a
short circuit occurs.
make sure that the insulation on the conductor is
undamaged. Also, take care not to damage the
insulation when clamping the conductor. Any
damage to the insulation could cause an electric
shock.
DANGER
Advertisement
Table of Contents
