D-Link DGS-3000-28XMP Quick Installation Manual page 9

(CLI).
To use the RJ-45 console port, the following equipment is needed:
 A terminal or a computer with both an RS-232 serial port and terminal emulation
software
 A console cable with a male DB9 connector on one end and an RJ-45 connection
on the other
To connect the RJ-45 console port on the Switch to the computer:
 Connect the male DB9 connector on the console cable (shipped with the Switch) to
the RS-232 serial port on the computer running terminal emulation software then
insert the RJ-45 connector into the RJ-45 console port on the front of the Switch.
To configure the terminal emulation software as follows:
 Select the appropriate serial port (COM1 or COM2).
 Set the data rate to 115200 baud.
 Set the data format to 8 data bits, 1 stop bit, and no parity.
 Set flow control to none.
Connecting to the Switch for the First Time
After successfully connecting to the Switch's console port and the Switch was turned on,
the boot-up procedure will be displayed, as shown below.
Figure 13 — COM Port Configuration
9