AEG L6WBN86JW User Manual page 27

2. Load the laundry one item at a time.
3. Turn the programme dial to the
desired drying programme
display shows the drying indicator
.
To have a good drying
performance do not exceed
the maximum drying loads
recommended in the user
manual. Do not set a spin
speed lower than the
automatic speed of the set
programme.
12.2 Drying at automatic
levels
The laundry can be dried at pre-defined
levels of dryness:
1. Press the Droogtegraad button again
and again until the display shows one
of the dryness level indicator:
• Strijkdroog;
• Kastdroog option;
• Extra droog option.
The display shows a time value,
calculated on the default load size. If the
amount of your laundry is more or less
than the default size, the appliance
adjusts automatically the time value
during the cycle.
2. Press the Start/Pauze button to start
the programme.
The display shows the door locked
indicator . The drying indicator
starts to flash.
You cannot set all dryness
levels for any type of
laundry.
12.3 Timed Drying
The laundry can also be dried with a
manual timed drying:
1. Press the Droogtijd button again and
again to set the drying time value.
The display shows 10 minutes.
• The display shows the set time
value: e.g.
. The
. Each time you
press this button the time value
increases by 5 minutes.
• After some seconds the display
shows a new time value: e.g.
The appliance calculates also the
duration of the anti-crease and
the cooling phases.
2. Press the Start/Pauze button to start
the programme.
• The display shows regularly a
new time value.
• The drying indicator
flash.
• The display shows the door
locked indicator
If you set only 10 minutes of
drying, the appliance
performs only a cooling
phase.
If the laundry is not sufficient
dry, set again a short drying
time.
12.4 End of the drying
programme
The appliance stops automatically.
• The acoustic signals operate.
• In the display comes on.
• The indicator Start/Pauze goes off.
• The last minutes of the drying cycle
the appliance performs a cooling and
anti-crease phase. The door is still
locked.
When the door locked
display, you can open the door.
1. Press the Aan/Uit button for some
seconds to deactivate the appliance.
After some minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
2. Remove the laundry from the
appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent mildew
and odours.
ENGLISH 27
.
starts to
.
goes off in the