Electronic Protection; Maintenance; Symbols On The Product; Symbols In This Manual - Ryobi R18PD5 Manual

ELECTRONIC PROTECTION

This drill includes advanced electronics designed to protect
any of these protections are triggered.
a case of overload, this resets as soon as the trigger is
released. It is recommended that you change to speed 1
application.
case of low voltage. It is recommended that you recharge
your battery to complete your application.
a case of excessive internal temperature. The drill cannot
resume working until it cools down to a normal temperature.

MAINTENANCE

The product should never be connected to a power
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product from the power
supply will prevent accidental starting that could cause
replacement parts, accessories and attachments.
Use of any other parts may create a hazard or cause
product damage.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
For greater safety and reliability, all repairs should be
performed by an authorised service centre.
E-TORQUE CONTROL
e-Torque control is a technology which automatically drives
depressing the trigger. The drill will begin small rotations at
a manageable speed. Release the trigger once the desired
depth is achieved.
screw bit is correctly seated and does not slip from the
stop early to prevent damage to the screw head or bit. If
this occurs, realign the bit with the screw head and depress
the trigger again.
NOTE: e-Torque control works with most materials and
applications but may not operate with certain materials or
4
Original Instructions
screws, e.g., machine screws into metal or plastic threads.

SYMBOLS ON THE PRODUCT

Safety alert
European Conformity Mark
British Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
V Volts
Direct current
min -1 Revolutions or reciprocations per minute
Chuck capacity
No-load speed
Please read the instructions carefully
before operating the product.
Drilling without impact
Auto screw driving mode
Percussion Drill
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or
retailer for recycling advice.

SYMBOLS IN THIS MANUAL

Note
Parts or accessories sold separately
Speed, minimum
Speed, maximum