Connecting The Water Line - LG GMX844MCKV Owner's Manual

global_main.book.book Page 15 Monday, May 16, 2022 3:05 PM
3
Remove the door by lifting it off the lower
hinge pin.
Refitting the Fridge and Freezer
Door
Refit the doors in the reverse sequence of their
removal once the appliance has been passed
through all access doors.
CAUTION
• Install the right fridge door first.
NOTE
• Disassembling/Assembling the water lines.
Collet Tube Insert line
a b c
• Gently insert the tube until only one of the tube's
lines is visible. Pull on the tube to make sure that
it is tightly fastened.
Correct
Incorrect
• If the water tube end is damaged, it should be
trimmed to ensure it does not leak when refitted.
e

Connecting the Water Line

This feature is only available on some models.
Water Supply Requirements
A cold water supply with water pressure between
138 kPa and 827 kPa (1.4-8.4 kgf/cm²) is required to
operate the water dispenser. If the refrigerator is
installed in an area with low water pressure (below
138 kPa), you can install a booster pump to
compensate for the low pressure.
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 138 kPa to 827 kPa (1.4-8.4 kgf/
cm²)
• Unplug the appliance before carrying out any
work on connecting the water line. Failure to do
Clip
d
so may cause electric shock.
• Only connect the water line to a cold water
supply. Failure to do so may cause the water
filter to malfunction. Water hammer (water
banging in the pipes) in house plumbing can
cause damage to appliance parts and can lead to
water leakage or flooding.
• Connect to potable water supply only.
• Connecting the water line must only be installed
by a qualified plumber and in accordance with
local legislation and regulations governing
water quality.
INSTALLATION
Not straight Damaged
f g
WARNING
15
Stretched