Mounting Of Indoor Unit Installation Plate - LG LS120HSV4 Installation Manual

Single zone high efficiency standard wall mounted

Hide thumbs Also See for LS120HSV4:

Installation manual (56 pages)

Engineering manual (54 pages)

Table Of Contents

Table of Contents

Mounting Installation Plate to Wall (090HSV4, 120HSV4, 180HSV4)

Follow the procedure and best practices below when mounting the

indoor unit's plate to a wall.

Procedure

1. Before installation of the plate, confirm the position the screw

types (A or B) between chassis and installation plate.

2. Mount the installation plate horizontally by aligning the centerline

using a leveling tool.

3. Use provided screws when mounting the plating.

• If mounting the unit on concrete wall, use field supplied anchor

bolts.

4. Observe the left and right rear piping clearance when drilling into

the wall, as shown in Figure 11 (090HSV4, 120HSV4) and Figure

12 (180HSV4).

Select location carefully. Unit should be anchored to a strong wall to pre-

vent unnecessary vibration.

• When choosing a location for the wall mount plate, be sure to take

into consideration routing of wiring for power outlets within the wall.

Contacting wiring can cause serious bodily injury or death.

• Use caution when drilling holes through the walls for the purposes

of piping connections. Power wiring can cause serious bodily injury

or death.

Refer to "Drilling Piping Hole in the Wall" on page 16 as

you follow procedure to install plate.

Figure 11: Installation Plate - 090HSV4, 120HSV4

Installation Plate

Place a level on raised tab

Unit Outline

17-13/32

Ø2-19/32

Left

rear piping

27/32

29/32

Unit: Inch

GENERAL INSTALLATION GUIDELINES

090HSV4, 120HSV4

17-13/32

Ø2-19/32

Right

rear piping

3- 24/32

17/32

Due to our policy of continuous product innovation, some specifications may change without notification.