Samsung S27A80 U Series User Manual page 30

2nd 3rd
PC/AV Mode
DisplayPort Ver.
Input Port Ver.
Auto Source Switch Auto Source Switch
USB-C Switch
Key Repeat Time
Power LED On
Description
Set PC/AV Mode to AV. The picture size will be enlarged.
This option is useful when you view a movie.
― Products with a display area of 16:9 or 16:10 are only supported.
Select the DisplayPort version to use.
― Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
Select an HDMI version.
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― If you set the
Input Port Ver. to 1.4, some high resolutions may not be supported because of bandwidth limitation of the HDMI 1.4 protocol.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the device.
When there is no signal, the display automatically switches to the newly connected device.
― This function may not be supported depending on the model or geographical area.
When there is no signal, the display automatically switches to the new device connected to the USB-C port.
― S27A80*U model only.
Control the response rate of a button when the button is pressed.
Acceleration, 1 sec or 2 sec can be selected. If
Configure the settings to enable or disable the power LED located at the lower part of the product.
• Working: The power LED is on when the product is turned on.
• Stand-by: The power LED is on when the product is turned off.
No Repeat is selected, a command responds only once when a button is pressed.
30