MAKINEX DPW-4000-VS Operator's Manual page 40

Oil leak from
pump
Water leaking at
pump
Engine shuts
down when
running
Engine will not
start
(1) operations which must be carried out at an authorised service centre
Worn gaskets
Worn gaskets
Worn pistons
Loose drain plug
pump overfilled
incorrect oil use
Oil seals worn
loose connections
Piston packings worn
Worn or broken O-rings
Pump head or tubes damaged
from freezing
Out of fuel
Low engine oil
Out of fuel
Low engine oil
wrong fuel
Rocker switch set to off
Fuel valve is in off position
Spark plug wire not connected to
spark plug
Faulty spark plug
Water in fuel
Flooded
Engine too hot
Choke in wrong position
Too much pressure builds up
Page 37 of 44
Replace the gaskets (1)
Replace the gaskets (1)
Replace the pistons (1)
Tighten drain plug
Check for correct amount
Drain and refill with correct type
and amount of oil
Replace seals (1)
Tighten connections
Check and replace (1)
replace O-rings
Check and replace (1)
Fill fuel tank
Add oil
Fill fuel tank
Add oil
Drain and refill recommended fuel
Set to on
Set to on
Check and make sure its wired
Check and replace
Drain tank and carburettor and
refill
Wait 5 minutes and re-crank
engine
Allow engine to cool
Change choke position
Release pressure