Table of Contents
Advertisement
STORAGE OF PRESSURE WASHER
1. Drain all water from high pressure line, coil it and store it in cradle of pressure
washer handle.
2. Drain all water from spray gun and spray wand by holding spray gun in
vertical position with nozzle pointed downward. Squeeze trigger to remove
fluids from spray gun and spray wand. Store in spray gun holder.
3. Store high pressure hose and spray wand so they are protected from damage.
It is RECOMMENDED that you follow these steps to protect the internal seals of
pressure washer when storing unit for more than 30 days and/or when freezing
temperatures are expected.
1. Obtain a funnel, 170g (6oz) of RV antifreeze and approximately 0.9m
(36inches) of garden hose with a male hose connector on one end.
CAUTION
2. Disconnect spark plug wire. Ensure it cannot touch any metal on pressure
washer.
3. Connect the 0.9m of garden hose to water inlet of pressure pump.
4. Add RV antifreeze.
5. Pull engine starter rope slowly several times until antifreeze comes out of
pressure hose connection of pressure pump.
6. Remove hose from water inlet of pressure pump.
7. Reconnect spark plug wire.
DISCONNECT BATTERY
1. Disconnect the negative lead from the battery terminal and store cap screw
and lock washer
2. Repeat for the positive battery lead.
3. Store the battery in a cool, dry place.
CHARGE THE BATTERY
For pressure washer equipped with batteries for electric starting, proper battery
maintenance and storage should be followed. An automatic battery charger with
automatic trickle charging capability should be used to charge the battery.
Maximum charging rate should not exceed 1.5amps. Follow the instructions
Use only RV antifreeze. Any other type of
antifreeze is corrosive and can damage pressure
pump.
Page 34 of 44
Advertisement
Table of Contents
