Operation - Jocel JP3GV009029 Instruction Manual

OPERATION

Lighting Burners
burner will ignite. Before releasing knob, ensure a flame is established, if the burner fails to
ignite, put into off position and try again.
If in case of a power failure or failure of the ignition, a match or lighting devise can be
used. Care must be taken when using this method.
The device shall not be operated for more than 15s. If after 15s the burner has not lit, stop
operating the device and open the compartment door and/ or wait at least 1 min before
attempting a further ignition of the burner.
In the event of the burner flames being accidentally extinguished, turn off the burner
control and do not attempt to re-ignite the burner for at least 1 min.
If you cannot light the flame even after several attempts, check the "cap" and "crown" (see
below diagram) are in the correct position. To put the flame out, turn the knob to the
symbol " ".
1.Burner cap
2.Burner crown
3.Burner plate
4.Ignition electrode
5. Thermocouple
When switching on the mains, after installation or a power cut, it is quite normal for the
spark generator to be activated automatically.
To ensure maximum burner efficiency, you had better use pots and pans with a flat bottom
fitting the size of the burner used (see table).
Triple
Semi-rapid
Rapid
If you use a saucepan which is smaller than the recommended size, the flame will spread
beyond the bottom of the vessel, causing the handle to overheat.
When use one pan with concave or convex bases, you can put one accessorial pan
support on the pan support. And use an appreciate pan on the accessorial pan support.
–
Simply press the knob in, turn anticlockwise to maximum and the
1
2
3
Burner Minimum Diameter
4
5
Maximum diameter
240mm
120 mm
160 mm
-25-
1
2
3
260mm
220 mm
240 mm
4