Cleaning The Appliance - Bosch KGF39SM30 User Manual

Cleaning the appliance

m
Caution
Do not use abrasive, chloride or acidic
■
cleaning agents or solvents.
Do not use scouring or abrasive
■
sponges. The metallic surfaces could
corrode.
Never clean shelves and containers
■
in the dishwasher. The parts may
become deformed!
Proceed as follows:
1. Before cleaning: Switch off
the appliance.
2. Pull out the mains plug or switch off
the fuse!
3. Take out the food and store in a cool
location.
4. Wait until the layer of frost has thawed.
5. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light.
6. Wipe the door seal with clear water
only and then wipe dry thoroughly.
7. Rinsing water must not run through
the drainage hole into the evaporation
area.
8. After cleaning reconnect and switch
the appliance back on.
9. Put the food back into the appliance.
Notes
Regularly clean the condensation
■
channel and drainage hole, Fig. +,
with a cotton bud or similar implement
to ensure that the condensation can
drain.
After cleaning, the stopper must be re-
■
inserted into the drainage hole
of the refrigerator compartment for
functional reasons.
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out glass shelves
Fig. %
Lift the glass shelves, pull forwards,
lower and swivel out to the side.
Removing the container
Fig. ,
Pull out the container all the way and lift
to detach it.
To insert the container, place on
the telescopic rails and push into
the appliance. Attach the container by
pressing it down.
Taking out the humidity filter
Fig. !/16
The humidity filter over the humidity
container can be taken out for cleaning.
To do this, first take out the humidity
container and pull out the humidity filter.
Lift off the filter cover, Fig. -, and take
out the filter. Clean in lukewarm water,
leave to dry and re-assemble.
Taking out the frozen food container
Fig. $
Pull out the frozen food container all
the way, lift at the front and remove.
General information for looking
after the surfaces
Clean surfaces with luke warm water
and a little washing-up liquid. After
cleaning, rub thoroughly dry.
en
39