Cub Cadet 2T6 Series Operator's Manual page 8

Installing the Chute
1. Remove the hex washer screws in the chute base. See Fig.
3-4.
Hex Washer
Screw
2. Align the holes in the chute base with the holes in the
lower chute and secure with the previously removed hex
washer screws. See Fig. 3-5.
8 S 3— A
ection SSembly
Figure 3-4
Figure 3-5
& S -U
et p
Installing the Chute Rotation Control Assembly
1. Remove the four hex washer screws from the back of the
handle (two on each side). See Fig. 3-6.
Figure 3-6
2. Using the four hex washer screws, install the chute rotation
control assembly. See Fig. 3-7.
Figure 3-7