Cleaning the Dispenser
Drawer
Detergent and fabric softener may build up in
the dispenser drawer. Remove the drawer and
inserts and check for buildup once or twice a
month.
1
Remove the detergent dispenser drawer by
pulling it straight out until it stops.
• Press down hard on the disengage button
and remove the drawer.
2
Remove the inserts from the drawer.
• Rinse the inserts and the drawer with
warm water to remove buildup from
laundry products. Use only water to clean
the dispenser drawer. Dry the inserts and
drawer with a soft cloth or towel.
3
To clean the drawer opening, use a cloth or
small, non-metal brush to clean the recess.
• Remove all residue from the upper and
lower parts of the recess.
4
Wipe any moisture off the recess with a soft
cloth or towel.
5
Return the inserts to the proper
compartments and replace the drawer.
32
Tub Clean (Optional)
Tub Clean is a special cycle to clean the inside
of the washing machine.
A higher water level is used in this cycle at
higher spin speed. Perform this cycle regularly.
1
Remove any clothing or items from the
washing machine and close the door.
2
Open the dispenser drawer and add
anti-limescale (e.g. Calgon) to the main
wash compartment.
3
Close the dispenser drawer slowly.
4
Power On and then press and hold Time
Delay and Pre Wash button for 3 seconds.
Then '
' will be displayed on the display.
5
Press the Start/Pause button to start.
6
After the cycle is complete, leave the door
open to allow the washing machine door
opening, flexible gasket and door glass to
dry.
CAUTION
• If there is a child, be careful not to leave the
door open for too long.
NOTE
• Do not add any detergent to the detergent
compartments. Excessive suds may generate
and leak from the washing machine.
EN