Rinse Agent - Thermador 800 Plus Series Instructions For Use Manual

Rinse Agent

To achieve proper drying, always use a liquid rinse agent, even if your
detergent contains a rinse agent or drying additive.
Rinse Agent Dispenser
Open the rinse agent dispenser by lifting the tab with your thumb.
NOTE: The dishwasher indicates low rinse agent either by showing the
symbol in the countdown display, or illuminating the refill rinse agent
light (model dependent).
Add liquid rinse agent to the dispenser as shown until the rinse agent
reservoir is full. Wipe up any excess rinse agent that puddles when the
dispenser reservoir is full.
Setting amount of rinse-aid
The amount of rinse-aid dispensed can be set from "r:00" to "r:06" .
• Open the door (for hidden controls only).
• Turn unit on by pressing the
• Hold down button "A" (see page 4) and press START until the display
indicates "H:00"
• Press " A" button until the display indicates "r:05".
• Release both buttons.
• Press "C"to select the desired setting.
• "r:00" means the Rinse Agent dispenser is off.
• "r:01" means the Rinse Agent dispenser is at the lowest setting.
• "r:02" means the Rinse Agent dispenser is low setting.
• "r:03" means the Rinse Agent dispenser is medium setting.
• "r:04" means the Rinse Agent dispenser is medium high setting.
• "r:05" means the Rinse Agent dispenser is high setting.
• "r:06" means the Rinse Agent dispenser is at the highest setting
• Save the selected language by pressing the
• Close the door (for hidden controls only).
Switching off rinse-aid refill indicator
• Set the rinse aid option to
NOTE: Do not change the amount of rinse-aid unless there are streaks (select
lower setting) or water stains (select higher setting) visible on the utensils.
8
ON/OFF button.
START button.
r:00