Table of Contents
Advertisement
Software network problems continued
Device Not Ready
If the pop-up message shown says Device Not ready, please wait a few minutes until the device is ready. The
device should then connect and the indicator turn Green.
Device Schematic Not Ready
The device has already been loaded with a DSP design.
1.
Please wait a few minutes to allow the connection to process. If it does not connect, restart the
Xilica Designer software and reboot the device.
Error in Firmware Upgrade
The pop up message shown will print out an error code. Retry the Firmware Upgrade again.
Device can communicate to Xilica Designer with UDP but cannot communicate with TCP
Right click the device in Network view and select "Device Set up". Select the "Network tab"
1.
2.
Click "TCP Test" / "UDP Test" to test TCP / UDP connections.
3.
If failed, please check your PC's firewall or router settings. If you are not connecting via Wi-Fi. make
sure that Wi-Fi is turned off.
4.
Click "Start Network Statistics" to see network statistic information.
5.
Once a change has been made, restart Xilica Designer and review your device connection.
NeuPanel: Connection troubleshoot
14
Advertisement
Table of Contents
