Luxen Home WHF1377 Instruction Manual

Product Name: 37-Inch H Modern Abstract Metal Floral Cement Outdoor Fountain
SKU #: WHF1377
Thank you for purchasing this LuxenHöme product. This product has been manufactured with the highest standards of
safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged parts. If
any parts are missing or damaged, do not attempt to assemble or use the product.

CARTON CONTENTS:

Description
Fountain
Pump
Compatible Pumps for this fountain:
Pump Model No.
JR350
Tools required for assembly: No tools required assembly.

ASSEMBLY INSTRUCTIONS:

1. Unpack the contents of the box and check to make sure that all items are accounted for and in good condition.
2. Remove the pump from the package and untie the power cord.
4. From the opening at the back of the fountain, insert the water supply tube into the pump outlet ①. Place the pump
3. Select a flat, level surface for the assembly and final location of your fountain.
5. Add clean water into the reservoir ②. The water level should be approximately 30mm lower than the edge of the
upright in the back of the fountain opening.
6. Connect the power cord from the pump to a properly grounded, grounding type receptacle (GFCI). ③
reservoir. Ensure the pump in your fountain is completely submerged in the water.
7. If installed properly, water flow in the fountain will begin shortly.
8. Adjust the flow rate (if applicable) to the maximum (+) position. If necessary, readjust the flow rate to the desired level
(remember to always disconnect from the power source before handling the pump).
9. Please do not use the electrical plug during wet weather conditions. Please note: On first use, there may be air in the
pump. It may take several minutes until all the air escapes.
Quantity
1
1
Instruction Manual
SAVE THESE INSTRUCTIONS–This manual contains important
safety and operating instructions for power units.