Fitting The Spinner Nose Cone; Fig. 58: Preparing The Threaded Stud (25008); Table 42: Inner Thread Size (25008) - ABB HT604643 Operation Manual

Operation Manual / A170-M.. - A175-M..
9 Disassembly and assembly / 9.10 Fitting the spinner nose cone
9.10

Fitting the spinner nose cone

If present:
The spinner nose cone (25012) and Loctite®542 are supplied by the ABB service station to-
gether with the overhauled cartridge group.
CAUTION
Total failure of turbocharger
If the spinner nose cone (25012) is not fitted correctly, or the socket screw
(25013) is not correctly tightened, the spinner nose cone can work loose dur-
ing operation and cause total failure of the turbocharger.
Follow the assembly instructions.
u
Always use a new socket screw (25013) and washer (25014) from the cus-
u
tomer spare part set (97070).
Only use new Loctite®542 supplied by the ABB service station.
u
Observe and note down control dimension Z.
u
Fig. 58: Preparing the threaded stud (25008)
Product
A170-M
A175-M
Table 42: Inner thread size (25008)
© Copyright 2020 ABB. All rights reserved. HZTL4033_EN
Size
M8
M10
Rev.G December 2020