Problem Solving Guide; Technical Problems - Miele G 7200 Operating Instructions Manual

Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
This section only lists faults that you can remedy yourself. All other faults are
shown in 
Fault FXX

Technical problems

Problem
The display remains
dark and the Start in-
dicator light is not
flashing after the dish-
washer has been
switched on with the
 button.
The  button does not
respond immediately or
only responds once it
has been pressed sev-
eral times.
The dishwasher stops
during a programme.
.
Cause and remedy
The dishwasher is not plugged in.
 Insert the plug and switch on at the socket.
The mains fuse has tripped.
 Reset the trip switch in the fuse box or replace the
fuse in the plug (see data plate for minimum fuse
rating).
 If the mains fuse trips again, contact the Miele
Customer Service Department.
Energy management: the door was opened or closed
shortly before the  button was pressed. As a result,
the dishwasher was already switched on. The elec-
tronic module requires a few seconds to be ready for
operation.
 Wait a few seconds after opening or closing the
door.
 Then press the  button.
The mains fuse has tripped.
 Reset the trip switch in the fuse box or replace the
fuse in the plug (see data plate for minimum fuse
rating).
 If the mains fuse trips again, contact Miele Ser-
vice.

Problem solving guide

77