Table of Contents
Advertisement
Subwoofer
•
Output power: 200W RMS (30% THD)/
150W RMS (10% THD)
•
Impedance: 3 ohm
•
Speaker drivers: 165 mm (6.5") woofer
•
Frequency response: 20 Hz-150 Hz
•
Dimensions (WxHxD): 123 x 309 x 369
mm
•
Weight: 3.6 kg
•
Cable length: 3 m
Wall mount
•
Dimensions (WxHxD): 37.6 x 50 x 46.4 mm
•
Weight: 0.05 kg/each
Remote control batteries
•
2 x AAA-R03-1.5 V
Laser
•
Laser Type (Diode): InGaN/AIGaN (BD),
AIGaInP (DVD/CD)
•
Wave length: 405 +7 nm/-7 nm (BD), 655
+10 nm/-10 nm (DVD), 790 +10 nm/-20
nm (CD)
•
Output power (Max. ratings): 20 mW (BD),
6 mW (DVD), 7 mW (CD)
EN
34
11 Troubleshooting
Warning
•
Risk of electric shock. Never remove the
casing of the product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check the
following points before you request service. If you
still have a problem, register your product and get
support at www.philips.com/welcome.
Main unit
The buttons on the home theater do not work.
•
Disconnect the home theater from the
power supply for a few minutes, then
reconnect.
ERROR appears on the display panel.
•
Disconnect the home theater from the
power supply for a few minutes, then
reconnect.
OPEN appears on the display panel.
•
Remove disc from the disc compartment.
•
If you remove an eight inch disc from the
disc compartment, the display remains
OPEN.
•
Make sure that the disc compartment is
closed.
•
Make sure that no object blocks the disc
compartment before closing it.
BLOCKED appears on the display panel.
•
Make sure that no object blocks the disc
compartment before closing it.
Cannot eject a disc from the disc compartment.
•
Press and hold
to eject.
•
In disc source, press
enter 159 to eject the disc.
•
Make sure that the home theater is not in
standby mode.
•
Disc compartment is blocked. Make sure
that no object blocks the disc compartment.
•
Close the disc compartment and open it
again to eject the disc.
(Stop) for three seconds
(Stop) and then
Advertisement
Table of Contents
