Philips Lumea SC1995 Manual page 17

English
16
Recycling
Technical specifications
Rated voltage
Rated frequency
Rated input
Protection against electric shock
Protections rating
Operating conditions
Spectrum of body attachment
Troubleshooting
Problem
The device/adapter
becomes warm during use
The 'ready to flash light'
doesn't light up when I
place the attachment on
my skin, but the cooling fan
works.
The 'ready to flash light'
lights up green but the
device does not produce a
flash when I press the flash
button.
- This symbol means that this product shall not be disposed of with normal
household waste (2012/19/EU).
- Follow your country's rules for the separate collection of electrical and
electronic products. Correct disposal helps prevent negative
consequences for the environment and human health.
This chapter summarizes the most common problems you could encounter
with the device. If you are unable to solve the problem with the information
below, visit www.philips.com/support for a list of frequently asked questions
or contact the Consumer Care Center in your country.
Possible cause
This is normal.
The overheat protection has
been activated.
The device needs to be reset. To reset the device, switch it off and
100V-240V
50Hz-60Hz
36W
Class II
IP 30 (EN 60529)
Temperature:+15 ºC to 35 °C
Relative humidity: 30% to 95%
>530nm
Solution
No action required.
When the overheat protection has been
activated, the fan still works. Do not
switch off the device, but let it cool down
for approx. 15 minutes before you
continue to use it.
switch it on again.