Table of Contents
Advertisement
Off Timer Plus
Configuring Off Timer
Off
Timer: Turn on
Off Timer
mode.
Turn Off
After: The off timer can be set within a range of 1 to 23 hours. The product will automatically
power off after the specified number of hours.
― This option is only available when
Off Timer
― For products for the market in some regions, the
product powers on. This is done in accordance with power supply regulations. If you do not want the timer to
activate, go to
→
System
→
Off Timer Plus
Configuring Eco Timer
Eco
Timer: Turn on
Eco Timer
mode.
Eco Off
After: The
Eco Off After
can be set between 10 and 180 minutes. The product will automatically
power off after the specified time has elapsed.
― This option is only available when
Eco Timer
PC/AV Mode
Set
PC/AV Mode
to AV. The picture size will be enlarged.
This option is useful when you view a movie.
•
Set to
PC
when connected to a PC.
•
Set to
AV
when connected to an AV device.
― Monitors with a display area of 16:9 or 16:10 are only supported.
― If the product is in HDMI1, HDMI2,
DisplayPort
settings of the source device.
press the JOG button to display the function-button screen and then select
→
System
→
PC/AV Mode
→ HDMI1, HDMI2,
DisplayPort
is set to On.
Off Timer
is set to automatically activate 4 hours after the
and set
Off Timer
to Off.
is set to On.
mode and the screen says
Check the cable connection and the
→
PC
or AV.
DisplayPort Ver.
Select your Displayport.
― Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
― If the product (when set to HDMI1,
HDMI2
or DisplayPort) is displaying the message
connection and the settings of the source device.
and then select
→
System
→
DisplayPort Ver.
― If setting the
DisplayPort Ver.
to 1.1, for the bandwidth limitation of the DisplayPort 1.1 protocol, the actual
maximum output refreshing rate of the graphics cards cannot achieve the level of 100 Hz/120 Hz/144 Hz.
HDMI Mode
Select the HDMI mode to use.
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― If you set the
HDMI Mode
to 1.4, some high resolutions may not be supported because of bandwidth
limitation of the HDMI 1.4 protocol.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the
device.
Source Detection
Select either
Auto
or
Manual
as the method to recognise input source.
Check the cable
press the JOG button to display the function-button screen
→
1.1
or 1.2↑.
32
Advertisement
Table of Contents
