Table of Contents
Advertisement
Trouble shooting
en
Upper glass cover
Before opening the top cover, remove any spills with a
cloth.
Use glass cleaner if possible.
For cleaning, remove the top cover. To do this, hold the
cover securely on both sides with both hands and pull it
upwards.
If the cover hinges become loose, note the letters
marked on them. The hinge with the letter R must be
fitted on the right, and the hinge with the letter L must
be fitted on the left.
After cleaning, re-assemble the top cover following the
same procedure in reverse order.
Only close the top cover once the burners have cooled
down.
Caution!
When using appliances that have a glass cover with
LED lighting
Do not use any of the following to clean the glass
cover
Undiluted cleaning agents
■
Abrasive cleaners or cleaning agents with a high
■
alcohol content
Aggressive cleaning agents, such as oven cleaner
■
or stain remover
High-pressure cleaners or steam jet cleaners
■
Harsh or scratchy cleaning agents
■
Hard scouring pads or cleaning sponges
■
The LED lighting and the hinges of the glass cover on
the hob must not come into contact with liquids.
Liquids will damage the printing, lighting and hinges on
the glass cover and prevent the LED lighting from
switching on.
32
3Trouble shooting
I f a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Rectifying faults yourself
You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 36
Fault
Possible
cause
The appliance is
Defective cir-
not working.
cuit breaker.
Power failure Check whether the kitchen light
The time is flash-
Power failure. Reset the time.
ing on the display.
The settings on
The child-
the appliance
proof lock is
cannot be config-
activated.
ured. A key sym-
bol has lit up on
the display or
†'""
.
Cleaning rec-
'–
appears on
ommenda-
the display.
tion.
The gas burner
Power cut or
does not ignite.
damp ignition
plugs.
The LED lighting
The LED light-
on the glass cover
ing button
is not working.
has not been
pressed.
The glass
cover on the
appliance is
not fully open
or is closed.
The glass
cover has not
been fitted
correctly.
--------
:
Warning – Risk of injury!
Incorrect repairs are dangerous. Do not attempt to
repair the appliance yourself. Repairs must only be
carried out by one of our trained after-sales engineers. If
the appliance is defective, call the after-sales service.
Notes/remedy
Check the circuit breaker in the
fuse box.
or other kitchen appliances are
working.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
Run the cleaning function in full.
The message can be dismissed
by pressing any button. It will con-
tinue to be displayed, however,
until the cleaning function has
been run in full.
Light the gas burner with a gas
lighter or a match.
Press the LED lighting button.
Open the glass cover on the appli-
ance fully.
Make sure that the hinges on the
glass cover have been fitted cor-
rectly; see the section entitled
"Glass cover".
Advertisement
Table of Contents
