Page 1
Please keep for future reference Thank you for purchasing this Elysium LX60B Pro charger. We are sure you will be pleased with its performance and features. In order to ensure that you obtain the maximum benefit from its operation, please read these instructions carefully.
• This unit is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to ensure that they can use it safely. • Young children should be supervised to ensure that they do not play with the Elysium LX60B Pro. • DO NOT attempt to charge non-rechargeable batteries. • The battery must be placed in a well ventilated area (for charging lead- acid batteries) • After charging, disconnect the battery charger from the power supply...
Lithium Ion/polymEr BAttEry SAFEty WArnings Ensure that the charger and battery are placed on a non-flammable surface whilst charging and ideally charge outdoors wherever possible. NEVER charge a Lithium ION/Polymer/Fe battery inside a vehicle whatever the circumstances. ALWAYS ensure that the charger is correctly set for the battery being charged, checking both voltage and capacity.
Page 6
Lithium Ion/polymEr/FE BAttEriEs Lithium battery packs must NEVER be discharged below 3 volts per cell as this will result in damage to the cells. If the voltage is allowed to drop below 3 volts per cell the battery voltage may seem to recover following a charge, but the battery may not then give its full nominal capacity and a reduction in performance is likely –...
15V. If this happens, please recheck the input power supply to make sure correct power is present. 100~240V AC Connect the mains lead to the Fusion Elysium LX60B Pro, then connect the AC plug to a regular AC100~240V wall socket. NOTE:...
Page 8
OpErAtion • When the charger is connected to the power supply the charger will show the battery mode that was last used. • If the battery TYPE button is briefly pressed, the present battery type (NiCd, NiMH, Lithium, or Pb ) will flash. While the existing battery type is flashing, every time the battery TYPE button is pressed, the following modes are shown in order: BATT TYPE BATT TYPE...
Page 9
• If the other buttons are pressed, or nothing is pressed, the present battery type stops flashing. • If the Battery TYPE button is pressed and briefly held, the recent & previous data will be shown until the Battery TYPE button is pressed. • If the ENTER button is briefly pressed, a parameter which can be adjusted starts to flash and if the ENTER button is pressed again, the next parameter starts to flash.
Page 10
Lithium Modes (Li-Ion/Li-Po/Li-Fe) BATT TYPE Lilo CHARGE 3.0A Lilo DISCHARGE Lithium Type C=3000mAh 10.8Vp D=0.50A 10.8Vp Lilo ENTER ENTER ENTER Lilo CHARGE 3.0A Lilo DISCHARGE Lithium Type C=3000mAh 10.8Vp D=0.50A 10.8Vp Lilo ENTER ENTER Lilo DISCHARGE Lilo CHARGE 3.0A Lithium Type D=0.50A 10.8Vp C=3000mAh 10.8Vp LiPo...
Page 11
Setting Battery Voltages For Li-Po Battery Pack LiPo CHARGE 3.0A Select the correct total battery voltage to be charged or C=3000mAh 11.1Vp discharged with the INC & DEC buttons – 3.7V, 7.4V, 11.1V, 14.8V, 18.5V and 22.2V [Vpack]. Setting Battery Voltages For Li-Fe Battery Pack LiFe CHARGE 3.0A Select the correct total battery voltage to be charged or C=3000mAh 11.1Vp...
Page 12
Pb Mode BATT TYPE PB CHARGE PB DISCHARGE C=3.0A 12Vpack D=0.5A 12Vpack ENTER ENTER PB CHARGE PB DISCHARGE C=3.0A 12Vpack D=0.5A 12Vpack ENTER ENTER PB DISCHARGE PB CHARGE D=0.5A 12Vpack C=3.0A 12Vpack START START BATTERY CHECK BATTERY CHECK WAIT PLEASE..WAIT PLEASE..
ScrEEn DisplAys Displays During Charge, Discharge and Cycle “BLC” will be shown if the balancer cable of the battery is connected to the balancing port of the charger. CHG: Charge CHG 0.30:25 00000 DCH 0.30:25 00000 D > C 0:00 00000 DCH: Discharge NC + 3.00A 5.200V NC - 0.50A 5.200V...
Error mEssAgEs Input voltage is below 11.0V or exceeds 15V. INPUT BATTERY VOLTAGE ERROR Battery is not connected to the charger’s output banana NO BATTERY sockets. Battery is connected to the output banana sockets in OUTPUT BATTERY reverse. REVERSE POLARITY The circuit of the charger has a problem.
Page 16
www. ogic .com Logic RC Limited 14 Hartham Lane Herford SG14 1QN United Kingdom...