Download Print this page
Fusion NX87 Operating Instructions
Fusion NX87 Operating Instructions

Fusion NX87 Operating Instructions

Dual nicd/nimh delta peak ac charger

Advertisement

Quick Links

DUAL NiCd/NiMH DELTA PEAK AC CHARGER
OPERATING INSTRUCTIONS
English
1.
Connect a suitable battery charge lead to the charger by clamping the bare ends of the charge lead into the charger
output, ensuring the correct polarity.
2.
Connect the input power lead into the socket on the back of the charger and connect the mains plug into the supply.
3.
Connect the battery to one of the charger outputs. The LED corresponding to this output will glow Red to indicate the
battery is fast charging.
4.
When the battery is fully charged, the peak circuitry will terminate the fast charge and the LED will turn Green to
indicate that the battery is now fully charged.
The approximate charging time for a fully discharged pack can be calculated by:-
DO NOT charge packs that cannot accept fast charging at the selected rate.
ALWAYS monitor the battery pack being charged and disconnect from the charger if the pack becomes excessively
hot.
NEVER leave the charger unattended whilst charging.
DO NOT fast charge batteries immediately after use while they are still warm. Allow to cool to ambient temperature
before charging.
This charger should only be used to charge NiCd or NiMH batteries.
DO NOT charge non-rechargeable or Lithium batteries using this charger.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning
the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
Logic RC Ltd, 12-18 Hartham Lane, Hertford, SG14 1QN, UK
NX87
CHARGING YOUR BATTERY
Time (hours) = Battery Capacity (mAh) / Average Charge Rate (2500mA) x 1.2
SAFETY PRECAUTIONS
l
www.
Mains Power
Outputs
Ni-MH Batteries
Average Charge Rate
Charge Status
Charge Leads
(included)
rc
ogic
SPECIFICATIONS
110~240V AC 50/60Hz
2 x independant chargers
6~8 Cells (7.2~9.6V)
2.5A (5A Pulses)
Dual Colour LED
2 x Tamiya/Molex
2 x TRX
.com

Advertisement

loading

Summary of Contents for Fusion NX87

  • Page 1 NX87 DUAL NiCd/NiMH DELTA PEAK AC CHARGER OPERATING INSTRUCTIONS SPECIFICATIONS • Mains Power 110~240V AC 50/60Hz • Outputs 2 x independant chargers • Ni-MH Batteries 6~8 Cells (7.2~9.6V) • Average Charge Rate 2.5A (5A Pulses) • Charge Status Dual Colour LED •...
  • Page 2 Deutsch BETRIEB Schliessen Sie die Ladekabel durch Anklemmen am Ladeausgang an (+ = rot, - = schwarz). Bitte den Lader entweder an das Netz oder über die die 12V- Anschlüsse an eine passende Spannungsquelle an- schliessen. Schliessen Sie den Akku am Ladeausgang Batt1 bzw. Batt2 an - die rote LED zeigt den Ladevorgang an. Sobald der Akku voll ist, wird die Elektronik die Ladung beenden und die grüne LED wird aufleuchten.
  • Page 3 Italiano Collegare i cavi di carica della batteria al caricabatteria inserendo le estremità senza guaina isolante all’uscita. Contr- ollare la polarità dei cavi (+ = rosso, - = nero). Collegare i cavi di alimentazione alla rete e quindi alla presa principale sul dorso del caricabatterie. Collegare la batteria da caricare all’uscita del caricabatterie.
  • Page 4 Suomi käYTTö Kiinnitä latausjohto laturin ulosottoliittimiin. Tarkista, että napaisuus tulee oikein (+ = punainen, - = musta). Liitä verkkovirtajohto laturin takana olevaan pistokkeeseen. Kytke verkkojohto verkkopistorasiaan. Kytke akku ( tai akut ) latausjohtoon. Kun akku on kytketty palaa punainen LED mikä merkitsee pikalatausta. Kun akku on täyteen ladattu, katkaisee delta-peak toiminto latauksen.