Adding Detergent And Care Product; Starting The Programme; Adjusting The "Ready In" Time Before The Programme Starts; Soaking Laundry - Siemens WM14SE9DN User Manual And Assembly Instructions

Ensure that the drum is empty.
2.
Separate the laundry and place it
3.
in the drum.
Note: Ensure that there is no laun-
4.
dry trapped in the door.
Close the door.
Adding detergent and care
product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent to the manual
dosing compartment.
Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Requirement: Find out the optimum
dosage for "detergent and care
product." → Page 36
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 21
If required, add the care product.
3.
Push in the detergent drawer.
4.

Starting the programme

Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start/Reload
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: End.
Adjusting the "Ready in" time
before the programme starts
You can readjust the selected "Ready
in" time before the programme starts.
Press Start/Reload
1.
Press Ready In
2.
the display indicates the desired
"Ready in" time.
Press Start/Reload
3.

Soaking laundry

You can soak the laundry before
washing in the appliance by pausing
the programme.
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start/Re-
.
load
To resume the programme, after
3.
the desired soaking time, press
Start/Reload

Adding laundry

Note: Please read the information in
the "Safety" → Page 4 and "Prevent-
ing material damage" → Page 11 sec-
tions to ensure that you use the appli-
ance safely.
Press Start/Reload
1.
The appliance is paused and
checks whether it is possible to
add or remove laundry. Take note
of the programme status.
Add or remove laundry.
2.
Basic operation en
.
repeatedly until
.
.
.
39