C&T Solution ACO-6000-KBL Series User Manual page 45

Chapter 2: Switches and Connectors
Step of Setting Power Ignition
Step 1
To select power ignition by PC/CAR switch.
Step 2
To select battery input voltage by 12V / 24V switch.
Step 3
To configure the power off delay time, please check the Delay Time Setting Options in advance.
Step 4
To connect the power and ignition power
Step 3
Switch 1 / 2 / 3
ON / ON / ON
ON / ON / OFF
ON / OFF / ON
ON / OFF / OFF
OFF / ON / ON
OFF / ON / OFF
OFF / OFF / ON
Example: Delay Time Setting for 5 minutes
1. If delay time set as "5 minutes"
2. The system will shut down 5 minutes later after
turning off the vehicle.
* System power On/Off signal must be generated by car ignition, don't manually
shut down after ignition off.
Power off delay time
5 second
1 minute
5 minutes
10 minutes
30 minutes
1 hour
2 hours
ACO-6000-KBL | User's Manual
Step 1
Pin 1-2 (Left): PC Power Mode
Pin 2-3 (Right): Power Ignition Mode
Step 2
Pin 1-2 (Left): Battery 24V Input Mode
Pin 2-3 (Right): Battery 12V Input Mode
Step 4
To connect the battery power and
ignition power
45